It can be extremely helpful to learn how to use a plunger. If your toilet won’t flush, you should read this article all the way through. How do you use a plunger, anyway? If you want to learn how to deal with stressful toilet clogs and similar shower drain or sink situations, learning the and outs of plunger use should be your first step. Understanding exactly how to properly use a plunger can spare you a lot of anxiety and time wasting, after all.
Make a Sensible Plunger Choice
If you want to plunge your toilet effectively, you should see to it that you use a plunger that makes sense. Go for a flange plunger that’s equipped with a cup that’s higher than that of a standard sink plunger. It should have an add-on that’s reminiscent of a sleeve as well. This is the flange. It should be situated under the cup. The flange should easily slide into the opening that’s inside of your toilet bowl.
It may be wise to steer clear of cup plunger use. These plungers aren’t able to manage toilet clogs as well.
Make Sure You Gather Everything You Need
It’s not only important to be armed with a suitable plunger. It’s just as important to get your hands on a pair of rubber gloves. After you do that, you may have to get some water for toilet bowl filling purposes.
Fill Up the Bowl
See to it that there is some standing water inside of the bowl. Immerse the plunger’s head for optimal results. It’s critical to have sufficient water to conceal the plunger cup’s rim.
Get the Plunger in Place
Fully remove the plunger’s flange from inside of the cup. Push the plunger down inside of the bowl slanted in order to fill the cup with adequate water. Moving straight into it may encourage the cup to catch excessive amounts of air. This may minimize plunging pressure considerably. Put the cup on the drain hole of the toilet. This will insert the flange into the hole. It will also allow the cup to create a full seal surrounding the hole’s exterior.
Maneuver the Toilet Plunger
Grasp the toilet plunger’s handle using two hands. Press downward onto the cup with ample strength. Bring it back up without ruining the seal that surrounds the hole. Keep doing this upward of six times in total. Once you’re done, remove the cup from the opening. Do this after you finish your final “shove.”
Your primary aim with this is to establish power that speedily transfers between suction and compression. It’s to do this within the drain as a means of loosening up the stubborn clog. If you suspect that your pressing is affecting the edge of the cup instead of traveling into the opening, that may point to an issue with your seal. Change the location of the seal and make another attempt.
Keep doing the same movements over and over again. Wait for the bowl to clear out on its own. Put the toilet plunger down.
Try Flushing
Take the lid of the tank off the toilet. Find the flapper. That’s the rubber trap door that has a round shape. This is situated in the middle of the lower section of the tank. If your toilet remains clogged, this will function as your water shutoff device of sorts. Try flushing the toilet now. If it works as it usually does, then you have finished your plunging job successfully. At this point, you can return the aforementioned lid to its designated tank spot. If you’re not able to flush, go down into the tank and press the trap door onto the hole. This will halt water flow between the bowl and the tank. Once the tank ceases to fill over and over again, continue plunging.
The truth is that plunging just isn’t successful 100 percent of the time. If your plunging attempts prove to be fruitless, you should use a toilet auger in order to clear things up. Then, you can reach out to a professional plumber to make an appointment. Toilet augers are similar to drain snakes and are made exclusively for toilet applications. They’re sometimes called closet augers, too.